In apartment complexes this is now the most common way of changing locks on a door.
Changing door locks do it yourself.
Door lock installation 1.
Remove the screws from the old lock on the inside of the door.
Chisel out any uneven recesses in the latch so that your new latch will fit perfectly.
Remove the two visible bolts in the turn assembly plate and then remove the turn plate.
Step 1 prop the door open.
Installing the new lock is an.
Install your new lockset making sure that the keyed section is on the outside.
Remove the old lock.
As stated above you need access to both sides of the door at the same time when changing locks.
You may also need to use a wire tool or a paper clip.
Step 3 install the new lock.
Step 1 purchase a new lock.
Before you begin make sure you have a new door lock set and a screwdriver or drill.
Go to the store and purchase a new lock.
Put the two pieces together and then screw in the door piece.
Begin by removing the screws from the door knob on the interior side of your door.
Slide the outside parts of the.
Insert the pins and reassemble the lock dump out the old pins insert the new key and use tweezers or small needle nose pliers to match the new colored pins to.
Replacing the lock on a front door.
Step 2 remove the screws from two halves of lock.
In some cases door latch plate mortises might need to be cut or enlarged.
Everything should work without having to put new holes unless you change the style of your door knob.
Open the door and.
Measure the back set of the door by measuring from the door latch to the middle of the door knob.
Remove the old deadbolt.
This allows you to pull the door.
Step 2 remove the old lock.
Purchase the same lock from a local hardware store.
Purchase a new lock.
Rekeying involves realigning the pins and springs in the inner workings of the lock in order to match the lock.
Step 3 remove screws from tongue plate.
Then screw in the new door knob piece and tighten it with your screwdriver.
Test the latch operation and the locking.
You will want to find one that is keyed on only.
Remove the two screws from the latch plate on the edge of the door and remove the latch from the opening.
Use a phillips head screwdriver to unfasten the two or three screws located on the inside knob plate.
Step 4 insert new tongue plate.
Now put the door handle together in the opposite way that you took it apart.
Once the new pins are in reverse the steps to reassemble the lock.
Changing locks on doors.
